Make grassland into an Artificial Turf

1. Check the entire turf field, whether the basic density and flatness of the turf are up to the required level, and after the arrival, the Artificial Turf can be paved.

2. Measure payoffs on the entire site, measure the position of the stadium line and mark it, mark it with different colors of ink, and determine the laying direction and position of the artificial turf.

3, began to lay Artificial Grass: the splicing tape on the lawn joint surface, and fixed with a steel nail on it, the nail head can not be raised, the joint area to be overlapped more than 10cm.

4. Apply glue on the joint interface. Before the glue dries, the cut lawn will be tiled and joined, so that each artificial grass closely adheres.

5. After the laying is completed, it is necessary to carefully check whether the bonding of the bonding areas is smooth and whether the bonding of the artificial grass is firm. Only after the inspections meet the requirements, can the construction of the next process be performed.

6. Cut out the green artificial turf at the position where the white line is to be set, insert it into the splicing zone, and apply glue on it. Then insert the cut white artificial turf court line into the marked course line before the paving. The position is bonded with the splicing tape.

7, according to the needs of the venue sprinkled with quartz sand and rubber particles. If it is necessary to throw quartz sand, pour the quartz sand or black rubber into the granulation machine, and push the granulator to carry quartz sand or black rubber particles onto the surface of the artificial turf. Brush the quartz sand or black on the back of the granulator. Colloidal particles, and make quartz sand or black rubber drops.

8, to promote the speed of the granulator should be uniform, not too fast or too slow, in order to uniform thickness.

9. After the quartz sand or black rubber particles are laid, it is necessary to check whether they are smooth and sufficient. The deficiency should be supplemented, and any impurities found in the pavement should be immediately removed to ensure quality.

10. The quartz sand or rubber particles in the pavement should be kept dry to facilitate the flow of quartz sand or rubber particles. After the quartz sand or rubber particle laying is completed, a hard brush or a light load drag heavy brush may also be used, and the brush back and forth makes the quartz sand drop fully dense.

11. Acceptance and exit after completion of laying.